Hey Guys, I have a 2016 Ruckus the Mods are
Rolling wrench CDI (I do have a tach)
Iridium spark plug
Pirelli SL26 tires
Pollini Variator
Dr Pulley 5g sliders
Stock clutch/Belt
Removed Air box with
K&N cone filter
Stock exhaust
38/82 jets
No shim
My ruckus is running but something seems off.
To start, the acceleration is definitely off from last year, I hit the gas and 0-25 is not what it was. My engine RPM shoots up but it feels like there is a disconnect from the engine and cvt spinning, to power coming out. I feel there is also a slight noise coming from the CVT box but I am unsure what is it. I've been careful to make sure the belt isn't pinched.
So even when I get speed. 30-40mph is awful and takes longer than last year.
Granted I hit 43-45 on the flats eventually, I only hit 9020 rpm which is barely above the rev limit.
The differences between last year and this year is,
pollini rollers to dr pulley sliders
Added the CDI and tach
I changed the stock tires
changed from old to new 38/82 jets
changed from a dual layer UNI pod filter to K&N
Had a place down the road do an oil/coolant/gear oil flush and clean the carb.
To any of the great tuners that might read this I thank you in advance for your response.