|
Post by fattykelps on Feb 15, 2009 16:55:12 GMT -5
Hey. I'm considering replacing the carb on my ruckus. Just wanted to know, when I get it from the factory; can I just pop it in and I'll be good to go? Or am I going to have to mess with the idle, mixture screw, reset the ECM, etc?
Figured someone might know....thanks.
|
|
|
Post by gomiotaku on Feb 15, 2009 17:12:31 GMT -5
You WILL have to do the ECM reset, since the TPS is disconnected. You'll be able to fine tune it- since you're already there, might as well get it set right! Idle should be a pretty quick set. I'm not sure if the mixture screw will have to be messed with- I doubt that the carbs that come on the Ruckus are all pre-run and tested, and we know the dealerships know nothing about doing it. gomi_
|
|
|
Post by Dandy Dan on Feb 16, 2009 16:25:04 GMT -5
Nice post gomi
|
|