Post by bags63 on Jul 24, 2014 23:33:55 GMT -5
I have a 2004 ruckus with a 2012 get motor I installed with a mojo fatty kit 12 1/2" stretch, low down shock new front tire (the old 2004 motor had a bad crank bearing due to no crankcase ventilation, don't buy 2002 to 2005 ruckus motors they have no crankcase ventalation) and the 2012 motor had about 1200 miles on it and a polini variater with 4g dr pulley sliders inside. I weigh 250 lbs. I installed a CDI and a relay for the blinkers cause i went to ALL LED lights. i have tried 7g rollers, 7.5 stock rollers, and the 4g sliders and i have a stock clutch right now but wanna get a dr pulley 3 pad clutch, just no money right now. and i want met gears too for some more top end. My top speed is about 30mph on flat and my friend rode it and he is 185 lbs and he could only hit 30mph and another guy rode it that is 138 lbs and he said he could only hit 30mph and thats with 4g sliders.i tried adjusting the air/fuel screw with a melted pen molded but would not turn it, gonna try an ant ppl say might work, so would adjusting the air/fuel screw help my top end? or just on idle? and i have slow jet 38 and main jet 85 with a two brothers exaust and open aftermarket air filters. I want to to get better top end and out of the hole, if i am going up a slight hill i go like 25 mph and up that hill into a wind like 15mph, and I ordered dr pulley 6.5 sliders to get higher top end, I was hitting rev limiter on my old motor with stock variater and stock weights, any help you can give me would be great thanks