|
Post by kairesq on Jun 5, 2008 17:44:00 GMT -5
Yea I just pulled the whole front floorboard out so I can reinstall if needed. I did have to cut it off where it mounts back by the seat. You could remove the whole thing and make another cover under the seat also it would be easy..
As for the frame I just took some tube and the welder and just sat in the garage and eyeballed it all. Cut a piece tack it and look. It worked out pretty good. Good luck.
|
|
|
Post by inteilla on May 24, 2011 1:38:49 GMT -5
Nice foot peg solution! I do have a non relevant question though; 1) Where did you get the headlight stone guards? They are exactly what I want too.
|
|
jlars
n00b Ruckster
WOT
Posts: 29
|
Post by jlars on Jun 23, 2011 19:50:33 GMT -5
I used some alum angle and bolted it to the floorboard.
|
|
|
Post by blackdeath on Nov 15, 2011 1:30:38 GMT -5
not that far up front, but managed to keep the floor and working gas door plus it matches the tubular frame very well if my stock bars wernt so far towards me, it would be even more comfortable
|
|
|
Post by skuuter on Nov 2, 2012 10:29:13 GMT -5
ALWAYS better to keep the Pegs above the Floorboard....I had Rear mounted Pegs like most Riders do and took Them off after one ride...They stayed planted against the road in every tight corner.....I still always scraped the Centerstand on Rucks during hard cornering...finally started shortening, heating, and re-shaping them to get more Lean....Great Looking Ruckus You have..... ;D
|
|
|
Post by Henk Schurink on Sept 19, 2022 7:17:57 GMT -5
where can I buy them?
|
|